Ghost32 Exe Apr 2026

ghost32.exe -clone,MODE=restore,SRC=\\server\share\master.gho,DST=1 -sure -rb | Issue | Details | |-------|---------| | No UEFI direct boot | Cannot boot ghost32.exe under UEFI natively – run it within Windows PE (64-bit) instead. | | GPT disks | Support exists in later Ghost versions (12+), but older versions only work with MBR. | | 4K sector drives (Advanced Format) | Older ghost32.exe may misalign partitions – test first. | | SSD TRIM | Ghost does not issue TRIM after restore; performance may degrade over time. | | Windows System Restore | Restoring an image over an existing Windows install can break boot config – use bootrec /fixboot afterward. | 6. Troubleshooting Common Errors | Error | Likely cause | Solution | |-------|--------------|----------| | Ghost cannot lock the drive | Ghost cannot get exclusive access (Windows running on that disk). | Boot from WinPE or use -vss for backup only. | | Destination drive too small | Target disk is slightly smaller than source. | Use -ir (image raw) if data fits. Or shrink source partition first. | | Internal error 36000 | Corruption in image file. | Use ghost32.exe -chkimg to validate. | | Unable to write to sector | Bad sectors on target drive. | Run chkdsk /f on target (if accessible) or replace drive. | 7. Modern Alternatives (Often Better) Given Ghost’s age, consider these free/modern tools for Windows imaging:

Example with DISM:

ghost32.exe is a powerful disk imaging tool. Incorrect usage (e.g., restoring an image to the wrong drive) will cause immediate, permanent data loss with no simple recovery. 1. What is ghost32.exe ? ghost32.exe is the 32-bit Windows executable for Symantec Ghost. Unlike the DOS version ( ghost.exe ), ghost32.exe runs directly within a full 32-bit or 64-bit Windows environment (including Windows PE, XP, 7, 10, 11). ghost32 exe

ghost32.exe -clone,MODE=create,SRC=1,DST=E:\backups\disk1_full.gho -z2 -sure -fx ghost32